Os-engines 55HZ-H Hyper Manuel d'utilisateur télécharger pdf (Page 5)

NOTES WHEN APPLYING AN ELECTRIC STARTER

Because of this initial tightness, a

standard electric starter may have

difficulty in rotating the engine when

cold, before it has been adequately

run-in. In this case, use a high-torque

type starter.

Do not over-prime. This could cause a

hydraulic lock and damage the engine

on application of the electric starter.

If over-primed, remove glowplug, close

needle-valve and apply starter to pump

out surplus fuel. Cover the head with a

rag to prevent pumped out fuel from

getting into your eyes.

A=B

Linking the throttle servo to the carburetor

Link the throttle servo to the carburetor using the throttle lever supplied.

Throttle control rod A and B should be equal length. Set the linkage so that

the servo output lever and throttle lever are parallel when the throttle stick on

the transmitter is at middle position. Installing hole intervals on the F lever and

on the J lever are different. Decide the lever to use according to the servo used.

Be sure to cut off another lever to avoid any interference.

1 2 3 4 5 6 7 8 9 10 ... 22 23

Pas de commentaire

Os-engines 55HZ-H Hyper Manuel d'utilisateur Page 5